Getting Started with STM32F103C8T6 on Windows 10: A Step-by-Step Guide

Are you struggling to get your STM32F103C8T6 microcontroller working with your Windows 10 machine? You're not alone. Many users have reported difficulties in connecting and programming this device, particularly those new to MCU programming like yourself. In this article, we'll walk you through the process of setting up your STM32F103C8T6 on Windows 10 using a USB TTL adapter.

Hardware Requirements

Before we begin, make sure you have the following hardware components:

* STM32F103C8T6 microcontroller

* USB TTL (PL2303) adapter

* USB to Micro-USB cable

* Jumper wires

* Breadboard

* Resistors and capacitors

Step 1: Connect Your STM32F103C8T6

Connect the STM32F103C8T6 to your breadboard. Make sure to connect the Vin pin to the power source (in this case, the USB TTL adapter) and the Gnd pin to the ground.

Step 2: Upload the Blink Script

Open the Arduino IDE and upload the blink script using the USB cable connected to your PC. This will ensure that your STM32F103C8T6 is recognized by the IDE.

Step 3: Connect Jumper Wires

Connect the jumper wires as follows:

* Vin pin to the power source

* Gnd pin to the ground

* Tx pin (A9) to the Rx pin (A10)

Step 4: Boot0 Pin Configuration

Set the Boot0 pin high by connecting it to Vdd (3.3V) or Vin (5V). This will enable bootloading mode.

Troubleshooting Tips

If you're still having trouble getting your STM32F103C8T6 recognized, try the following:

* Check that your USB TTL adapter is properly connected and configured.

* Ensure that your jumpers are securely connected to the correct pins.

* Try using a different USB cable or port on your PC.

Getting started with MCU programming can be challenging, especially when dealing with compatibility issues. However, by following these simple steps, you should be able to get your STM32F103C8T6 microcontroller working on Windows 10 using a USB TTL adapter. Remember to double-check your connections and troubleshoot any issues that arise. Happy coding!

Windows 10 stm32 stlink driver